A polycarbonate swimming-pool enclosure must be designed for humidity, chlorinated air, condensation, wind, snow, temperature and repeated cleaning. Select sheet and framing as one envelope; a generic statement that polycarbonate “resists chlorine” is not adequate compatibility evidence.
Map the pool environment
Record indoor and outdoor temperature, relative humidity, pool chemistry, ventilation, splash zones and cleaning products. Vapour can condense at cold surfaces and carry chemicals into joints or channels. Exposure differs between a high roof panel, a low wall beside the water and a movable enclosure component.
Select solid or multiwall by function
Solid sheet and multiwall panels provide different transparency, insulation, stiffness and edge details. Choose from the enclosure’s daylight, privacy, heat-loss, span and appearance targets. For multiwall, plan rib direction and closure so internal cells are protected and any designed drainage remains effective.
Verify chemical compatibility
Ask for guidance covering the offered grade, coating, sealant, gasket and cleaning chemical. Concentration, contact time, temperature and stress all affect risk. Trial the full cleaning process on a loaded or fabricated sample where the exposure could cause crazing, swelling or seal failure.
Design the complete enclosure
- calculate panels and frame for local wind, snow and maintenance actions;
- provide movement clearance without losing retention;
- route condensation away from occupied edges and sensitive hardware;
- separate dissimilar materials where corrosion or staining is possible;
- define safe access, replacement and storm-position procedures.
Approve representative details
Review a corner, base, operable joint and channel termination rather than only a flat sample. Check visibility, drainage, gasket compression, fastener access and cleaning. If the enclosure retracts, include wheel loads, repeated movement and locking conditions.
SinoPlastix can identify sheet options and prepare cut panels from an approved drawing. The enclosure manufacturer must validate framing, ventilation, weather sealing and compatibility for the actual pool environment.